| View previous topic :: View next topic |
| Author |
Message |
budstahl
Veteran Member
Joined: 20 Nov 2019
Posts: 123
Location: Jönköping
|
 Posted: Sun Feb 09, 2020 3:38 am Post subject: Burbank Benge 3x ML |
 |
|
Hi !
On a Burbank Benge 3X ML, where on the trumpet does it say 3 and where does it say ML ?
Best regards, Ulf |
|
| Back to top |
|
 |
shofarguy
Heavyweight Member
Joined: 18 Sep 2007
Posts: 7012
Location: AZ
|
| Posted: Sun Feb 09, 2020 8:16 am Post subject: Re: Burbank Benge 3x ML |
|
|
| budstahl wrote: | Hi !
On a Burbank Benge 3X ML, where on the trumpet does it say 3 and where does it say ML ?
Best regards, Ulf |
During the Burbank era, the bell number was stamped on the bell tail ferrule. However, the #3 was not always stamped, so if there is no number on the ferrule, it is a #3 bell. The bore designation should be stamped on the #2 valve casing on the opposite side from the serial number.
_________________
Brian A. Douglas
Flip Oakes Wild Thing Bb Trumpet in copper
Flip Oakes Wild Thing Flugelhorn in copper
There is one reason that I practice: to be ready at the downbeat when the final trumpet sounds. |
|
| Back to top |
|
|
budstahl
Veteran Member
Joined: 20 Nov 2019
Posts: 123
Location: Jönköping
|
| Posted: Sun Feb 09, 2020 10:19 am Post subject: Re: Burbank Benge 3x ML |
|
|
| shofarguy wrote: | | budstahl wrote: | Hi !
On a Burbank Benge 3X ML, where on the trumpet does it say 3 and where does it say ML ?
Best regards, Ulf |
During the Burbank era, the bell number was stamped on the bell tail ferrule. However, the #3 was not always stamped, so if there is no number on the ferrule, it is a #3 bell. The bore designation should be stamped on the #2 valve casing on the opposite side from the serial number. |
Okay , thank you very much ! |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|
